Lesson 32 of 46 · Chemistry
Acids, bases, pH and buffers
Identify acids, bases and conjugate pairs, find pH from powers of ten without a calculator, predict the pH of salts and explain how buffers work.
About 22 minutes
In this lesson
- Identify Brønsted–Lowry acids, bases and conjugate pairs, and tell strong from weak.
- Calculate pH and pOH from concentrations written as powers of ten, including after neutralisation and dilution.
- Predict whether a salt solution is acidic, neutral or basic.
- Explain how a buffer resists changes in pH and find its pH from the acid-to-base ratio.
The idea
Acids and bases as proton transfer
In the Brønsted–Lowry model an acid donates a proton () and a base accepts one. In water a free proton does not exist; it attaches to a water molecule as , often written for short.
When an acid loses a proton it becomes its conjugate base; when a base gains one it becomes its conjugate acid. A conjugate pair differs by exactly one : , , . Water acts as a base towards and as an acid towards , so it is amphoteric. The stronger an acid, the weaker its conjugate base. (In the wider Lewis model an acid accepts an electron pair and a base donates one.)
Strong and weak
A strong acid ionises completely in water: , , , , , and for its first proton. Strong bases are the hydroxides of group 1 and the soluble hydroxides of group 2, such as . A weak acid ionises only partly and sets up an equilibrium; carboxylic acids and carbonic acid are examples, as ammonia and amines are of weak bases. Its strength is measured by the acid dissociation constant
A larger , or a smaller , means a stronger acid. "Strong" describes the extent of ionisation, not the concentration: a dilute solution of a strong acid is still a strong acid.
Water and the pH scale
Water ionises very slightly, and at
Neutral water has , so pH 7 at . Each pH unit is a factor of ten in : a solution at pH 3 is a hundred times more acidic than one at pH 5.
pH from powers of ten
With no calculator, write every concentration as a power of ten.
- : , so pH 2.
- : , pOH 3, so pH 11.
- : two per formula unit give , pOH 2, pH 12.
When the number in front is not 1, the pH lies between two integers. Since , and , a concentration of gives . For a weak acid that ionises only slightly,
Diluting a strong acid tenfold raises its pH by one unit, but dilution can never carry an acid past pH 7: near neutrality the ions from water itself take over.
Neutralisation and the pH of salts
An acid and a base react to give a salt and water; the net ionic reaction for a strong acid with a strong base is . At the equivalence point the moles of supplied equal the moles of . When unequal amounts are mixed, find the excess in moles, then divide by the total volume.
The salt left over is not always neutral:
| Salt made from | Example | Solution |
|---|---|---|
| strong acid + strong base | , | neutral, pH 7 |
| weak acid + strong base | basic: takes from water | |
| strong acid + weak base | acidic: gives to water |
Buffers
A buffer contains a weak acid and its conjugate base in comparable amounts, for example ethanoic acid with sodium ethanoate. Added is taken up by the base (); added is taken up by the acid (). The ratio of the two changes only a little, so the pH barely moves. Its pH is given by the Henderson–Hasselbalch equation:
With equal amounts of acid and base, ; a tenfold excess of base gives , and a tenfold excess of acid gives . A buffer works best within about one unit of its . In blood, carbonic acid and hydrogencarbonate form the main buffer that holds the pH close to 7.4.
Worked examples
Example 1: pH after mixing an acid and a base
of is mixed with of . What is the pH of the mixture?
Work in millimoles: is and is .
They neutralise one to one, leaving of in excess.
Divide by the total volume, : .
.
Answer
The pH is 2. Dividing the excess by instead of the total gives and a pH of about 1.7, which is the usual slip.
Example 2: pH of a weak acid
A weak acid has . What is the pH of a solution?
The acid ionises only slightly, so use .
, and its square root is .
.
Check the approximation: is of , so very little of the acid has ionised, as the formula assumes.
Answer
The pH is 4. Treating the acid as strong gives and pH 2, which ignores the small .
Example 3: A buffer meets a strong acid
One litre of buffer contains of ethanoic acid and of sodium ethanoate (). What is its pH, and roughly what is the pH after of is added? Compare with adding the same to one litre of pure water.
Equal amounts of acid and base: .
The added reacts with ethanoate: the base falls to and the acid rises to .
. The ratio is about , just under 1, so its logarithm is a small negative number, about : the pH is about , close to .
In pure water the same acid gives , so the pH would drop from 7 to 2.
Answer
The buffer starts at pH 4.76 and falls only to about 4.7, while pure water would fall from 7 to 2. Answering "about 2" applies the strong-acid calculation and ignores the ethanoate that consumes the added .
Common traps
Reading pH as if it were a concentration
pH is a logarithm with a minus sign. A lower pH means more , and one unit is a factor of ten. Diluting an acid tenfold raises its pH by one; it does not divide the pH by ten.
Answering with pOH
For a base you usually find first, which gives the pOH. Finish with . A base whose answer comes out below 7 is a sign that this step was skipped.
Counting hydroxides or protons per formula unit wrongly
gives of , not . Check the formula before turning the concentration into a power of ten.
Assuming every salt is neutral
A salt is neutral only when both its parent acid and parent base are strong. Sodium ethanoate is basic and ammonium chloride is acidic; ask which parent was weak.
Check yourself
Choose an answer to each question: you will see at once whether it is right, and why.
Question 1: Diluting a strong acid
pH
of hydrochloric acid at pH 2 is diluted with water to a total volume of . What is the pH of the diluted solution?
Show the answer
Answer: C. 3
Working
At pH 2, . The volume grows from to , ten times, so and the pH is 3.
Why the other options are wrong
- A. Dilution lowers , which raises the pH; it cannot make the solution more acidic.
- B. Treats pH as unchanged by dilution, but has fallen tenfold.
- D. One tenfold dilution moves the pH by one unit; it would take far more water to approach neutrality, and an acid never passes pH 7.
- E. This is the pOH of the diluted solution, not its pH.
What carries over
Each tenfold dilution of a strong acid raises its pH by one unit.
Question 2: Which salt solution is basic?
Acids and bases
Which of these aqueous solutions has a pH greater than 7 at ?
Show the answer
Answer: B.
Working
Sodium ethanoate is the salt of a weak acid and a strong base. The ethanoate ion is a base: , which makes the solution basic.
Why the other options are wrong
- A. The ammonium ion is a weak acid (the conjugate acid of ammonia), so this solution is acidic.
- C. Both parents, and , are strong, so the solution is neutral.
- D. A salt of a strong acid and a strong base; neither ion reacts with water, so the pH is 7.
- E. A strong acid, with a pH of about 1 at this concentration.
What carries over
A salt is basic when its anion is the conjugate base of a weak acid.
Question 3: pH of a buffer
Buffers
A buffer contains a weak acid at () and its salt at . What is its pH?
Show the answer
Answer: D. 6
Working
. The ratio , and , so .
Why the other options are wrong
- A. This is the pH of the weak acid alone: , pH about 3.5; it ignores the salt.
- B. The ratio has been inverted: would apply if the acid were in excess.
- C. This is the , the pH only when acid and base are equal; here the base is ten times the acid.
- E. Subtracts the correct pH from 14, as if the equation gave the pOH; it gives the pH directly.
What carries over
In a buffer, more base than acid puts the pH above the pKa, by one unit for each factor of ten.
Flashcards
Recall the answer before you flip each card, then say whether you knew it. Cards you miss come back at the end.
- Brønsted–Lowry acid and base
- An acid donates a proton (H⁺); a base accepts one. A conjugate pair differs by exactly one proton.
- Ionic product of water at 25 °C
- , so .
- pH of a 0.001 mol/L strong base
- , so pOH is 3 and pH is .
- pH of a weak acid
- , valid when only a small fraction of the acid ionises.
- Sodium ethanoate solution: acidic, neutral or basic?
- Basic: the ethanoate ion is the conjugate base of a weak acid and takes protons from water.
- Henderson–Hasselbalch equation
- ; with equal acid and base, .
Key points
An acid donates a proton and a base accepts one; a conjugate pair differs by one proton.
and at ; each unit is a factor of ten.
Salts of a weak acid and a strong base are basic; salts of a strong acid and a weak base are acidic.
A buffer is a weak acid with its conjugate base; .
All questions here are original and written for UniExamer; none comes from the test maker.
Written and reviewed by the UniExamer education and assessment team. Every worked example and check question was checked before publication. If you find a mistake, write to support@uniexamer.com.