Lesson 41 of 46 · Physics
Electric charge, fields and circuits
Charge, Coulomb's law, fields and potential, Ohm's law, series and parallel circuits and electrical power, with numbers you can work by hand.
About 22 minutes
In this lesson
- Use Coulomb's law and the definitions of field, potential difference and energy for charges.
- Apply Ohm's law and the resistivity formula, and reduce series and parallel networks to find currents and voltages.
- Calculate electrical power and energy with the form of the power formula that fits the data.
The idea
Electric charge
Charge comes in two kinds, positive and negative: like charges repel and unlike charges attract. It is measured in coulombs (C) and is quantised: every charge is a whole multiple of the elementary charge , carried by the proton (positive) and the electron (negative). Charge is conserved. Rubbing a plastic rod with a cloth moves electrons from one to the other; it does not create charge. In conductors, such as metals and ionic solutions, charges move freely; in insulators they do not.
Coulomb's law
Two point charges and a distance apart exert forces on each other along the line joining them:
Like gravitation, this is an inverse-square law: double the distance and the force falls to a quarter; double one charge and the force doubles. The two forces form a third-law pair, so they are equal in size even when the charges are not.
Electric field and potential
The electric field at a point is the force per unit positive charge placed there, , in N/C (equivalently V/m). A point charge produces a field of size , pointing away from a positive charge and towards a negative one. Field lines start on positive charges and end on negative ones, and they are closer together where the field is stronger.
The potential difference (voltage) between two points is the work done per unit charge in moving a charge between them, , in volts (J/C). A charge moved through a potential difference gains or loses energy . An electron accelerated through 1 V gains one electronvolt: .
Between two parallel plates a distance apart with a potential difference , the field is uniform: . Such plates form a capacitor, which stores charge , where is its capacitance in farads; the energy stored is .
Current, resistance and Ohm's law
Current is the rate of flow of charge, , in amperes (). By convention, current flows from the positive terminal round the circuit to the negative one; the electrons in a metal move the other way.
The resistance of a component is , in ohms (). Ohm's law says that for a metal at constant temperature is constant, so and the current is proportional to the voltage. The resistance of a wire depends on its material and its shape:
where is the resistivity of the material, the length and the cross-sectional area. Longer wires resist more; thicker wires resist less.
Series and parallel
| Series | Parallel | |
|---|---|---|
| Current | the same through each | splits; the branch currents add up to the total |
| Voltage | splits; the parts add up to the total | the same across each |
| Total resistance |
Two resistors in parallel have a combined resistance of ; two equal ones give half the resistance of one. A parallel combination always has less resistance than its smallest branch, because each new branch gives the current another path.
These rules come from Kirchhoff's laws. The current flowing into a junction equals the current flowing out, because charge is conserved. Round any closed loop the potential differences add up to zero, because energy is conserved.
Electrical power and energy
The power delivered to a component is
Choose the form that uses what you know. At a fixed voltage, such as the mains, a smaller resistance draws a larger current and more power. The energy transferred is . Electricity bills count kilowatt-hours: .
Solving circuit questions
Reduce the circuit step by step: combine each parallel group, then the series parts, to find the total resistance. Use for the current from the supply. Then work back outwards, finding the voltage across each part and the current in each branch. Finally check that the branch currents add up to the total and that the voltages round each loop add up to the supply voltage.
Worked examples
Example 1: The force between two charged spheres
Two small spheres carry charges of and , and their centres are 30 cm apart. Taking , find the force between them. What is the force if the distance is halved?
Convert to SI: , , .
Substitute: .
Work the powers of ten: , and . Second route: , and . Both charges are positive, so the force is repulsive.
Halving the distance multiplies the force by : .
Answer
The spheres repel each other with 0.60 N, and with 2.4 N at 15 cm. Doubling the force to 1.2 N when the distance is halved is the tempting wrong answer: the law is inverse-square.
Example 2: A series and parallel circuit
A 12 V battery of negligible internal resistance is connected to a resistor in series with a parallel pair of and resistors. Find the current from the battery, the current in each resistor of the pair, and the total power.
The parallel pair: .
Total resistance , so the battery current is .
The series resistor takes , leaving 6 V across the pair. Currents: and , which add up to 3.0 A as they should.
Total power: . Check part by part: , and , total 36 W.
Answer
The battery supplies 3.0 A; 1.0 A flows through the resistor and 2.0 A through the one; the circuit uses 36 W. The larger current takes the branch with the smaller resistance.
Example 3: Stretching a wire
A wire has a resistance of . It is drawn out to twice its length, its volume staying the same. What is its new resistance?
The volume is fixed, so doubling the length halves the cross-sectional area .
In , the numerator doubles and the denominator halves, so is multiplied by .
New resistance: .
Answer
The stretched wire has a resistance of . Answering allows for the extra length but forgets that the wire has also become thinner.
Common traps
Halving instead of quartering
In Coulomb's law the distance is squared. Doubling the separation divides the force by 4, and tripling it divides the force by 9. Write the factor for each quantity separately, then combine them.
Adding resistances in parallel
Two resistors in parallel make , not . If your total for a parallel group is larger than its smallest branch, you have added the resistances instead of their reciprocals.
Thinking current is used up
The same current flows out of a resistor as flows into it; charge is conserved. What the resistor takes is energy, which is why the potential falls across it. Every component in a single series loop carries the same current.
Picking a power formula that hides a change
suggests that more resistance means more power, while suggests the opposite. Both are right; use the one whose other quantity is fixed. For components in parallel the voltage is fixed, so the one with the smaller resistance dissipates more power.
Check yourself
Choose an answer to each question: you will see at once whether it is right, and why.
Question 1: Changing charges and distance
Electrostatics
Two point charges exert a force of size on each other. Both charges are doubled and their separation is tripled. What is the new force?
Show the answer
Answer: B.
Working
The product of the charges is multiplied by , and by . So .
Why the other options are wrong
- A. Doubles only one charge; both are doubled, which multiplies their product by 4.
- C. Divides by the distance factor rather than its square; Coulomb's law is an inverse-square law.
- D. Inverts the factor; increasing the separation must reduce the force.
- E. Multiplies by the square of the distance factor instead of dividing by it.
What carries over
In an inverse-square law, multiplying the distance by divides the force by .
Question 2: Voltage across a parallel pair
Circuits
Three identical resistors are connected so that two are in parallel and this pair is in series with the third. The combination is connected to a 9.0 V supply of negligible internal resistance. What is the voltage across the parallel pair?
Show the answer
Answer: D. 3.0 V
Working
The pair has , so the total is and the current is . Across the pair: . Check: the series resistor takes 6.0 V, and . Second route: the voltage divides in proportion to resistance, .
Why the other options are wrong
- A. This is the whole supply voltage; it ignores the series resistor, which takes its own share.
- B. This is the voltage across the single series resistor, not across the pair.
- C. Splits the voltage equally, as if the pair had the same resistance as the single resistor; the pair has only .
- E. Divides the supply voltage by , which gives a current in amperes, and reads it as a voltage.
What carries over
In series, the supply voltage divides in proportion to the resistances.
Question 3: Energy used by a heater
Circuits
A heater draws a current of 5.0 A from a 200 V supply for 30 minutes. How much energy does it transfer?
Show the answer
Answer: D.
Working
The power is and the time is , so . Second route: 1 kW for 0.5 h is 0.5 kWh, and .
Why the other options are wrong
- A. This is the power in watts, the energy per second, not the energy transferred in 30 minutes.
- B. Uses 30 s instead of 30 minutes, which is 1800 s.
- C. Takes the power as ; that ratio is the resistance, and the power is .
- E. Uses one hour instead of half an hour; that is 1 kWh, but the heater ran for 0.5 h.
What carries over
Energy is power multiplied by time: time in seconds gives joules, time in hours with power in kilowatts gives kilowatt-hours.
Flashcards
Recall the answer before you flip each card, then say whether you knew it. Cards you miss come back at the end.
- The elementary charge
- ; every charge is a whole multiple of it.
- Coulomb's law
- with ; doubling the distance quarters the force.
- Field between parallel plates
- Uniform, with , in V/m.
- Ohm's law and resistivity
- ; a wire of length and cross-section has .
- Resistors in series and in parallel
- Series: , with the same current through each. Parallel: , with the same voltage across each.
- The three forms of electrical power
- , in watts.
Key points
Coulomb's law is inverse-square: , with .
Moving a charge through a potential difference transfers energy .
Series resistances add; a parallel combination has less resistance than its smallest branch.
Electrical power is , and energy is power multiplied by time.
All questions here are original and written for UniExamer; none comes from the test maker.
Written and reviewed by the UniExamer education and assessment team. Every worked example and check question was checked before publication. If you find a mistake, write to support@uniexamer.com.